|
|
| (19 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| '''Requirements:
| | #REDIRECT [[Device assembly]] |
| # Screwdriver | |
| # Solder Iron
| |
| # Solder
| |
| # Flux
| |
| # 3D Printer / 3d printing service
| |
| # [[bcMeter Parts]]
| |
| | |
| == Watch Time Lapse! ==
| |
| [https://player.vimeo.com/video/568114940 Time lapse of assembly]
| |
| | |
| '''Current version is designed for absolute simplicity so as little as possible SMD components and parts with large footprints are used. Start assembling by soldering the smallest parts first (MMBT3904 + MCP3426).
| |
| <br>Then add THT passive parts piece by piece according to description on the PCB and the BOM.'''
| |
| | |
| ==Most important:==
| |
| | |
| # Place IRL81A (IR Emitter) and LPT80A (Sensor) in adapters D and E, seal with hot glue and solder wires to the corresponding vias on the PCB. Long leg is anode (positive). [[File:Sensor-emitter-brackets.jpg|thumb|left]]<br clear=all>
| |
| # Place adapters D and E in the case A and B. Emitter to top case. Seal with (hot) glue or tape. [[File:Brackets-in-lower-case.jpg|thumb|left]]<br clear=all>
| |
| # Put pump in place and do a test run for leakage. [[File:Pump.jpg|thumb|left]]<br clear=all>
| |